Mount the optional gsm external antenna on the desired site surface and connect its connector to the powermax pro as shown below. Be sure to select external antenna in define comm. Refit the panel and restore the mains and battery power.
Visonic POWERMAX REMOTE PROGRAMMER SOFTWARE Installation
Fully supervised wireless alarm control system.
To access the installer’s menu and navigate within it, refer to figures 1 and 2 and proceed as follows:
Quick guide to primary alarm control operations Plug in the gsm module and fasten it with the screw (see drawing below). Specifications 2.1 general data zones number: Mode from the control panel (see section 4.5.2).
De5468u 1 table of contents quick guide to primary alarm control operations.2 contact list form.2
28 wireless, 2 hardwired (zones 29 & 30). If the partition feature is disabled, all zones, user for powermax pro with 2 installer codes, installer codes, and features of the powermax pro will operate as in code (default 8888) and master installer code a regular unit. The powermax pro control panel is supplied with 2 instruction manuals: Partitioning refers only to purchased control panels that support the partitioning feature.
Ii) enter and exit the installer menu iii) disconnect gsm unit and install it again iv) replace sim card v) replace the gsm unit rssi low the gsm communicator has detected that gsm network signal is weak move the panel and gsm unit to another location.
Click the < next > button until the display reads: Introduction the internal gsm module enables the powermax pro system to operate over a gsm/gprs cellular network. The powermax+ control panel is supplied with 2 instruction manuals: The system is designed to function in a way that appeals to the user but
This manual refers to powermax pro v5.2.07 and above.
Appendices a.1 and a.2 will help you prepare an installation plan. The system is designed to function in a way that appeals to the user but The control panel will prompt you for the installer code. This manual refers to powermax pro v5.2.07 and above.
This manual refers to powermaxcomplete v2.0.00 and above.
1 2 release screws 2. The powermax control panel is supplied with 3 instruction manuals: Remove the battery power, and remove the link from the def jumper. Message to the installer the powermaxcomplete control panel is supplied with 2 instruction manuals:
Partitioning refers only to purchased control panels that support the partitioning feature.
Appendices a.1 and a.2 will help you prepare an installation plan. The express needs removal of the internal cover. Enrolling wireless devices and keyfob transmitters away (optional home) mode. 2 de5468u compatibility of this manual this manual should be used with powermax pro v5.2.07 and above.
Partitioning refers only to purchased control panels that support the partitioning feature.
The system is designed to function in a way that appeals to the user but Enter the valid installer code (9 9 9 9) if this is the The system is designed to function in an appealing way to the user and also offers. I) move the panel and gsm unit to another location.
This manual refers to powermax pro v5.2.07 and above.
Introduction overview the powermaxpro is a wireless alarm control system that provides protection against burglary, fire and Message to the installer the powermaxcomplete control panel is supplied with 2 instruction manuals: Appendices a and b to the installation instructions will help you prepare an. Must be handed over to the master user after testing the system).
Identify the two left hand jumper pins marked def and fit a jumper across them.
Database contains 1 visonic powermaxpro manuals (available for free online viewing or downloading in pdf): Powermax pro gsm internal gsm module for powermax pro installation instructions 1. Click < ok > to select the installer’s mode.
