T8 Led Tube Installation Instructions fluorescentlight Senior LED

Rotate led lamp until lamp locks in place. Keep these instructions for future reference. Risk of product damage • do not replace conventional lfl directly with led tubes.

T8 Wiring Diagram Complete Wiring Schemas

Remove old fluorescent tubes 3.

2.) inspect the t8 fa8 led tube for any damage or abnormality.

T8 led wiring instruction diagram (with no ballast) 1) hot (black) wire (120v live wire) to any pin on one end of troffer. Cut off the power before installing. Reconnect to the mains supply and check for correct operation. • tube may fall down if not installed properly, follow installation instructions.

3) insert t8 led replacement into luminaire fixtures with no ballast.

Installation instructions plug and play procedure 1. Applying power to wrong end will cause a direct short of the ac power when turned on. Disconnect power to the fixture at source. Exxon lighting corporation isnotresponsibleforanydamage or harm caused by improper handing and installation of our t8 tube.

Install at a location at or near the point of each supply connection of sign 2.

• wear safety glasses and proper aid during installation and maintenance. Proper grounding is required for safety. Do not simply switch off fixture. Input/output wiring information printed on both driver & tube ledrays inc.

3.remove ballast and starter or electronic ballast where applicable, and the corresponding wires including branch circuit wires and ballast wires.

The pins are not polarity sensitive 4. Insert the led tube and dummy starter. When the ac input side is attached to the ac power side on fixture, you are ready to go. Access the ballast by removing ballast cover 4.

Led tubes need a dc voltage to work.

Remove lens or diﬀuser (if applicable) 3. Take extra care to ensure the lamps have been rotated and “fully” seated into the lamp holder. 2) cold (neutral, white) wire to any of other three pins on troffer. Read instructions carefully before installing.

Before installing lamps, verify that luminaire

Switch shall open all ungrounded conductors 4. Close fixture and find your ac input side to led tube lamp. Power length type 8w06t8ww 25600020 warm white (3000k). Ensure you are working with standard fluorescent light fixture.

Unpack the led tube light:

Turn off the power to the light fixture at the breaker panel before installation. 9w 2’ led t8 / 14w 3’ led t8 / 22w 4’ led t8 / 24w 5’ led t8 / 28w 6’ led t8 twin fitting b. Installation this guide explains the steps necessary to install our t8 fa8 led tubes properly into your existing fixture to replace afluorescentt8fa8 tube. G4 sep t8 led tube lamp.

Remove the led tube from its packaging, make sure it’s suitable and check for any damages.

Switch shall have a manual actuator which shall be protected against mechanical injury and shall be operable before entering the electrical enclosure 3. Open the diffuser from the light fixture. Your fixture may have more than 1 tube light and may/may not have a starter. Power must be applied to the end cap labeled “ac input”.

Put led tube into the lighting fixture.

Bring led lamp to luminaire and insert lamp pins into luminaire lamp holders 5. Product must be installed in accordance with the national electrical code or your local electrical code. Remove lens and wiring compartment if applicable; • read all precautions, warnings, instructions contained in this document.

Turn power circuit back on from breaker.

Remove existing ﬂuorescent lamps from the luminaire. Install this kit only in luminaries that have the construction features and dimensions shown in the photographs and/or drawing and where the input. If not qualified, do not attempt installation. If you are not familiar with these codes and • warning:

Led t8, ballast by pass —installation guide page 2 of 3 instructions for single ended wiring installation removing existing fluorescent system 1.

Please dispose of these items properly as they contain mercury. Proled®double ended bypass t8 led. Proled luminaires must be wired in accordance with the national electrical code and all applicable local codes.